The event loop uses a `select` on multiple channels. However, reading from a closed channel in Go always yields the channel's zero value. The processor and scheduler close their channels when done, and since these channels are always ready to receive, the event loop keeps spinning on them.
This changes `routine.terminate()` to not close the channel, and also removes `stopDemux` and instead uses `events` channel closure to signal event loop termination.
Fixes#4687.
Fixes#828. Adds state sync, as outlined in [ADR-053](https://github.com/tendermint/tendermint/blob/master/docs/architecture/adr-053-state-sync-prototype.md). See related PRs in Cosmos SDK (https://github.com/cosmos/cosmos-sdk/pull/5803) and Gaia (https://github.com/cosmos/gaia/pull/327).
This is split out of the previous PR #4645, and branched off of the ABCI interface in #4704.
* Adds a new P2P reactor which exchanges snapshots with peers, and bootstraps an empty local node from remote snapshots when requested.
* Adds a new configuration section `[statesync]` that enables state sync and configures the light client. Also enables `statesync:info` logging by default.
* Integrates state sync into node startup. Does not support the v2 blockchain reactor, since it needs some reorganization to defer startup.
- only run tests when .go, .mod, .sum files have been touched
- only run proto checks when .proto files have been touched
Signed-off-by: Marko Baricevic marbar3778@yahoo.com
to prevent data races
note: when we check the ConflictingHeadersEvidence, the copy is used.
Closes#4749
Also, iterate over valToLastHeight instead of loading validators. While it might be slower than accessing a single key in goleveldb, the new code is better adapted to ConsensusParams changes.
to prevent malicious nodes from sending us large messages (~21MB, which
is the default `RecvMessageCapacity`)
This allows us to remove unnecessary `maxMsgSize` check in `decodeMsg`. Since each channel has a msg capacity set to `maxMsgSize`, there's no need to check it again in `decodeMsg`.
Closes#1503
Fixes#2593@alexanderbez This is used in a single place in the SDK, how upset are you about removing it?
______
For contributor use:
- [x] ~Wrote tests~
- [x] Updated CHANGELOG_PENDING.md
- [x] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [x] Updated relevant documentation (`docs/`) and code comments
- [x] Re-reviewed `Files changed` in the Github PR explorer
- [x] Applied Appropriate Labels
The checklist and message in the default PR description were sometimes getting
included in commit messages. This change moves that text from the PR description
to a comment from a [Probot tool](https://probot.github.io/apps/auto-comment/).
merged the existing store into pool, consolidated the three buckets into two, used block height as a marked for committed evidence, evidence list recovers on start up, improved error handling
Reduce the number of targets and make the buildsystem more
flexible by parsing the TENDERMINT_BUILD_OPTIONS command
line variable (a-la Debian, inspired by dpkg-buildpackage's
DEB_BUILD_OPTIONS), e.g:
$ make install TENDERMINT_BUILD_OPTIONS='cleveldb'
replaces the old:
$ make install_c
Options can be mix&match'd, e.g.:
$ make install TENDERMINT_BUILD_OPTIONS='cleveldb race nostrip'
Three options are available:
- nostrip: don't strip debugging symbols nor DWARF tables.
- cleveldb: use cleveldb as db backend instead of goleveldb;
it switches on the CGO_ENABLED Go environment variale.
- race: pass -race to go build and enable data race detection.
This changeset is a port of gaia pull request: cosmos/gaia#363.
Fixes#4739, kind of. See #4740 for the proper fix.
---
For contributor use:
- [x] Wrote tests
- [x] Updated CHANGELOG_PENDING.md
- [x] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [x] Updated relevant documentation (`docs/`) and code comments
- [x] Re-reviewed `Files changed` in the Github PR explorer
- [x] Applied Appropriate Labels
merged the existing store into pool, consolidated the three buckets into two, used block height as a marked for committed evidence, evidence list recovers on start up, improved error handling
- Move core stateless validation of the Header type to a ValidateBasic method.
- Call header.ValidateBasic during a SignedHeader validation.
- Call header.ValidateBasic during a PhantomValidatorEvidence validation.
- Call header.ValidateBasic during a LunaticValidatorEvidence validation.
lite tests are skipped since the package is deprecated, no need to waste time on it
closes: #4572
Co-authored-by: Anton Kaliaev <anton.kalyaev@gmail.com>
- regenerate proto using docker image
- on proto breakage a different compiler is used to generate some more helper functions, on master the same one os not used, reverting back to the one used on master to undo further confusion till proto-breakage is merged
Signed-off-by: Marko Baricevic <marbar3778@yahoo.com>
* Added "Edit this page" box
* Fixed link styles
* Fixed build-time errors
* Updated VuePress and dependencies
<!-- < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < ☺
v ✰ Thanks for creating a PR! ✰
v Before smashing the submit button please review the checkboxes.
v If a checkbox is n/a - please still include it but + a little note why
☺ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -->
## Description
<!-- Add a description of the changes that this PR introduces and the files that
are the most critical to review.
-->
Closes: #XXX
______
For contributor use:
- [ ] Wrote tests
- [ ] Updated CHANGELOG_PENDING.md
- [ ] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] Updated relevant documentation (`docs/`) and code comments
- [ ] Re-reviewed `Files changed` in the Github PR explorer
- [ ] Applied Appropriate Labels
<!-- < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < ☺
v ✰ Thanks for creating a PR! ✰
v Before smashing the submit button please review the checkboxes.
v If a checkbox is n/a - please still include it but + a little note why
☺ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -->
## Description
- this pr add a check box for making sure labels are added to PRs
Signed-off-by: Marko Baricevic <marbar3778@yahoo.com>
______
For contributor use:
- [ ] Wrote tests
- [ ] Updated CHANGELOG_PENDING.md
- [ ] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] Updated relevant documentation (`docs/`) and code comments
- [ ] Re-reviewed `Files changed` in the Github PR explorer
Closes: #4530
This PR contains logic for both submitting an evidence by the light client (lite2 package) and receiving it on the Tendermint side (/broadcast_evidence RPC and/or EvidenceReactor#Receive). Upon receiving the ConflictingHeadersEvidence (introduced by this PR), the Tendermint validates it, then breaks it down into smaller pieces (DuplicateVoteEvidence, LunaticValidatorEvidence, PhantomValidatorEvidence, PotentialAmnesiaEvidence). Afterwards, each piece of evidence is verified against the state of the full node and added to the pool, from which it's reaped upon block creation.
* rpc/client: do not pass height param if height ptr is nil
* rpc/core: validate incoming evidence!
* only accept ConflictingHeadersEvidence if one
of the headers is committed from this full node's perspective
This simplifies the code. Plus, if there are multiple forks, we'll
likely to receive multiple ConflictingHeadersEvidence anyway.
* swap CommitSig with Vote in LunaticValidatorEvidence
Vote is needed to validate signature
* no need to embed client
http is a provider and should not be used as a client
Updates our Security Policy with takeaways from Security Advisory
Lavender and the associated security releases.
Thank you to @melekes and @alessio for reviewing earlier versions
of this document.
Closes: #4695
Verify /block_results and /validators responses from an HTTP client using the light client.
Added count and total to /validators response.
Refs #3113
in TestPEXReactorDialsPeerUpToMaxAttemptsInSeedMode
Closes#4668
______
For contributor use:
- [x] Wrote tests
- [ ] ~~Updated CHANGELOG_PENDING.md~~
- [x] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] ~~Updated relevant documentation (`docs/`) and code comments~~
- [x] Re-reviewed `Files changed` in the Github PR explorer
## Description
move tests for abci_cli, abci_app and app_tests to github actions
______
For contributor use:
- [ ] Wrote tests
- [ ] Updated CHANGELOG_PENDING.md
- [ ] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] Updated relevant documentation (`docs/`) and code comments
- [ ] Re-reviewed `Files changed` in the Github PR explorer
Followup from #4588. Allow the first `SaveBlock()` call in an empty block store to be at any height, to start from a truncated block history. Subsequent `SaveBlock()` calls must be for contiguous blocks.
______
For contributor use:
- [x] Wrote tests
- [ ] ~Updated CHANGELOG_PENDING.md~
- [x] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [x] Updated relevant documentation (`docs/`) and code comments
- [x] Re-reviewed `Files changed` in the Github PR explorer
The service logging can be a bit unclear. For example, with state sync it would log:
```
I[2020-04-20|08:40:47.366] Starting StateSync module=statesync impl=Reactor
I[2020-04-20|08:40:47.834] Starting state sync module=statesync
```
Where the first message is the reactor service startup, and the second message is the start of the actual state sync process. This clarifies the first message by changing it to `Starting StateSync service`.
______
For contributor use:
- [ ] ~Wrote tests~
- [ ] ~Updated CHANGELOG_PENDING.md~
- [ ] ~Linked to Github issue with discussion and accepted design OR link to spec that describes this work.~
- [ ] ~Updated relevant documentation (`docs/`) and code comments~
- [x] Re-reviewed `Files changed` in the Github PR explorer
See #4588 for original change.
I believe this is appropriate. Anything else that needs to be updated?
______
For contributor use:
- [ ] ~Wrote tests~
- [x] Updated CHANGELOG_PENDING.md
- [x] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] ~Updated relevant documentation (`docs/`) and code comments~
- [x] Re-reviewed `Files changed` in the Github PR explorer
## Description
ADR to address the process for proving an amnesia attack (as a form of global evidence) from `PotentialAmnesiaEvidence` detected by light clients
______
For contributor use:
- [ ] Wrote tests
- [ ] Updated CHANGELOG_PENDING.md
- [ ] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] Updated relevant documentation (`docs/`) and code comments
- [ ] Re-reviewed `Files changed` in the Github PR explorer
______
For contributor use:
- [ ] Wrote tests
- [ ] Updated CHANGELOG_PENDING.md
- [ ] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] Updated relevant documentation (`docs/`) and code comments
- [x] Re-reviewed `Files changed` in the Github PR explorer
## Description
The minor release process is changing in order to not have major release changes sitting in the pull request tab.
This changes from taking master and releasing from master to creating a branch that you cherry-pick commits into.
There are two options on labeling which pull requests to include in a minor release:
1. Use the label `R:minor` to know which pull requests to include then remove the label when those pull requests have been included in a release.
2. Create an Issue where pull request numbers are added. then the issue is closed when the release is done.
this process should be followed after 0.33.3
______
For contributor use:
- [ ] Wrote tests
- [ ] Updated CHANGELOG_PENDING.md
- [ ] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] Updated relevant documentation (`docs/`) and code comments
- [ ] Re-reviewed `Files changed` in the Github PR explorer
Tess Rinearson
Erik Grinaker
Marko
Anton Kaliaev
Callum Waters
Alessio Treglia
dependabot-preview[bot]
Alexander Bezobchuk
Diep Pham
Denis Fadeev