The `NodeInfo` interface does not appear to serve any purpose at all, so I removed it and renamed the `DefaultNodeInfo` struct to `NodeInfo` (including the Protobuf representations). Let me know if this is actually needed for anything.
Only the Protobuf rename is listed in the changelog, since we do not officially support API stability of the `p2p` package (according to `README.md`). The on-wire protocol remains compatible.
This implements a new `Transport` interface and related types for the P2P refactor in #5670. Previously, `conn.MConnection` was very tightly coupled to the `Peer` implementation -- in order to allow alternative non-multiplexed transports (e.g. QUIC), MConnection has now been moved below the `Transport` interface, as `MConnTransport`, and decoupled from the peer. Since the `p2p` package is not covered by our Go API stability, this is not considered a breaking change, and not listed in the changelog.
The initial approach was to implement the new interface in its final form (which also involved possible protocol changes, see https://github.com/tendermint/spec/pull/227). However, it turned out that this would require a large amount of changes to existing P2P code because of the previous tight coupling between `Peer` and `MConnection` and the reliance on subtleties in the MConnection behavior. Instead, I have broadened the `Transport` interface to expose much of the existing MConnection interface, preserved much of the existing MConnection logic and behavior in the transport implementation, and tried to make as few changes to the rest of the P2P stack as possible. We will instead reduce this interface gradually as we refactor other parts of the P2P stack.
The low-level transport code and protocol (e.g. MConnection, SecretConnection and so on) has not been significantly changed, and refactoring this is not a priority until we come up with a plan for QUIC adoption, as we may end up discarding the MConnection code entirely.
There are no tests of the new `MConnTransport`, as this code is likely to evolve as we proceed with the P2P refactor, but tests should be added before a final release. The E2E tests are sufficient for basic validation in the meanwhile.
closes: #5770closes: #5769
also, include node ID in the output (#5769) and modify NodeKey to use
value semantics (it makes perfect sense for NodeKey to not be a
pointer).
After a reactor has failed to parse an incoming message, it shouldn't output the "bad" data into the logs, as that data is unfiltered and could have anything in it. (We also don't think this information is helpful to have in the logs anyways.)
`abci.Client`:
- Sync and Async methods now accept a context for cancellation
* grpc client uses context to cancel both Sync and Async requests
* local client ignores context parameter
* socket client uses context to cancel Sync requests and to drop Async requests before sending them if context was cancelled prior to that
- Async methods return an error
* socket client returns an error immediately if queue is full for Async requests
* local client always returns nil error
* grpc client returns an error if context was cancelled before we got response or the receiving queue had a space for response (do not confuse with the sending queue from the socket client)
- specify clients semantics in [doc.go](https://raw.githubusercontent.com/tendermint/tendermint/27112fffa62276bc016d56741f686f0f77931748/abci/client/doc.go)
`mempool.TxInfo`
- add optional `Context` to `TxInfo`, which can be used to cancel `CheckTx` request
Closes#5190
## Description
Hardcode ed25519 to dialTCPFn in e2e tests.
I will backport `DefaultRequestHandler` fixes
This will be replaced when grpc is implemented.
## Description
- remove installation of protoc
- use buf protoc to generate proto stubs
prior to approving could someone test locally. I restarted my docker instance and its been stuck for 20+ minutes
Closes: #XXX
* Don't use state sync for nodes starting at initial height.
* Also remove stopped containers when cleaning up.
* Start nodes in order of startAt, mode, name to avoid full nodes starting before their seeds.
* Tweak network waiting to avoid halts caused by validator changes and perturbations.
* Disable most tests for seed nodes, which aren't always able to join consensus.
* Disable `blockchain/v2` due to known bugs.
In #5488 the E2E testnet generator changed to setting explicit `StartAt` heights for initial nodes. This broke the runner, which expected all initial nodes to have `StartAt: 0`, as well as validator set scheduling in the generator. Testnet loading now normalizes initial nodes to have `StartAt: 0`.
This also tweaks waiting for misbehavior heights to only use an additional wait if there actually is any misbehavior in the testnet, and to output information when waiting.
Closes#5291. Adds a randomized testnet generator. Nightly CI job will be submitted separately. A few of the testnets can be a bit flaky, even after disabling known-faulty behavior and making minor tweaks, and the larger networks may be too resource-intensive to run in CI - this will be optimized separately.
This was a missing test case from the old P2P tests removed in #5453, which makes sure that all nodes are able to peer with each other regardless of how they discover peers.
Fixes#2795, since the default CI testnet uses a combination of (partially meshed) persistent peers and PEX-based seed nodes.
Partial fix for #5291.
This adds a basic set of test cases for core network invariants. Although small, it is sufficient to replace and extend the current set of P2P tests. Further test cases can be added later.
Debian testing caused Docker image build failures:
```
The following packages have unmet dependencies:
libc6-dev : Breaks: libgcc-8-dev (< 8.4.0-2~) but 8.3.0-6 is to be installed
E: Error, pkgProblemResolver::Resolve generated breaks, this may be caused by held packages.
```
It does not appear that we actually need testing, so removing it.
* format: add format cmd & goimport repo
- replaced format command
- added goimports to format command
- ran goimports
Signed-off-by: Marko Baricevic <marbar3778@yahoo.com>
* fix outliers & undo proto file changes
* Update makefile
- these two files were taken from the sdk with adjustments for usage in TM
Signed-off-by: Marko Baricevic <marbar3778@yahoo.com>
* .phony
* remove slate
* more tools
* circleci update 1/2
* fixed typo
* fixed bash error
* '<<' must be escaped in 2.1
* fixed invalid config
* removed golangci-lint from tools. runs as github app now
* one more issue in Circle config
* some more work on the Circle config
* minor changes
* fiddling with restore cache config
* fiddling with restore cache config
* added commands in circle config. makefile changes
* bash shenannigans
* bash shenannigans
* fighting the config demons
* fighting the config demons, v2
* fighting the config demons, v3
* updating p2p dockerfile
* updating p2p dockerfile
* updating p2p test
* updating p2p test
* testing circle config
* testing circle config
* remove dontcover command
* its the weekend, custom docker image
* Update to using go mod from dep
* Remove references to make get_vendor_deps
* Specify go version
* Set GO111MODULE=on and add -mod=readonly
* Fix exported env
* switch to using go1.12 everywhere
* Fix test scripts
* Typo:
* Prepend GO111MODULE=on
* remove dep cache
* Revert "remove dep cache"
This reverts commit 45117bda
Signed-off-by: Ismail Khoffi <Ismail.Khoffi@gmail.com>
* bring back the dependency cache and change it to cache modules instead
of vendored deps; also:
- bump version for dependency cache
- bump version on pkg-cache (includes modules directory)
Signed-off-by: Ismail Khoffi <Ismail.Khoffi@gmail.com>
* remove some more traces of dep:
- remove Gopkg.(toml | lock)
- update contributing guidlines
- set global default in circleci (GO111MODULE=on)
Signed-off-by: Ismail Khoffi <Ismail.Khoffi@gmail.com>
* global var failed for `test_cover` with
`go: unknown environment setting GO111MODULE=true`
although the var was `GO111MODULE: on`
Signed-off-by: Ismail Khoffi <Ismail.Khoffi@gmail.com>
* Changelog pending entry
Signed-off-by: Ismail Khoffi <Ismail.Khoffi@gmail.com>
* Add bbolt dependency to go.mod
Signed-off-by: Ismail Khoffi <Ismail.Khoffi@gmail.com>
* move -mod=readonly to build flags
* validate reactor messages
Refs #2683
* validate blockchain messages
Refs #2683
* validate evidence messages
Refs #2683
* todo
* check ProposalPOL and signature sizes
* add a changelog entry
* check addr is valid when we add it to the addrbook
* validate incoming netAddr (not just nil check!)
* fixes after Bucky's review
* check timestamps
* beef up block#ValidateBasic
* move some checks into bcBlockResponseMessage
* update Gopkg.lock
Fix
```
grouped write of manifest, lock and vendor: failed to export github.com/tendermint/go-amino: fatal: failed to unpack tree object 6dcc6ddc14
```
by running `dep ensure -update`
* bump year since now we check it
* generate test/p2p/data on the fly using tendermint testnet
* allow sync chains older than 1 year
* use full path when creating a testnet
* move testnet gen to test/docker/Dockerfile
* relax LastCommitRound check
Refs #2737
* fix conflicts after merge
* add small comment
* some ValidateBasic updates
* fixes
* AppHash length is not fixed
Callum Waters
Erik Grinaker
Anton Kaliaev
Aleksandr Bezobchuk
Tess Rinearson
Marko
dongsam
Erik Grinaker
Erik Grinaker
Thane Thomson
Jack Zampolin