After a reactor has failed to parse an incoming message, it shouldn't output the "bad" data into the logs, as that data is unfiltered and could have anything in it. (We also don't think this information is helpful to have in the logs anyways.)
## Description
Add simple `NoBlockResponse` handling to blockchain reactor v1. I tested before and after with erik's e2e testing and was not able to reproduce the inability to sync after the changes were applied
Closes: #5394
Before: scheduler receives psBlockProcessed event, but does not mark block as processed because peer timed out (or was removed for other reasons) and all associated blocks were rescheduled.
After: scheduler receives psBlockProcessed event and marks block as processed in any case (even if peer who provided this block errors).
Closes#5387
When a peer is stopped due to some network issue, the Reactor calls scheduler#handleRemovePeer, which removes the peer from the scheduler. BUT the peer stays in the processor, which sometimes could lead to "duplicate block enqueued by processor" panic WHEN the same block is requested by the scheduler again from a different peer. The solution is to return scPeerError, which will be propagated to the processor. The processor will clean up the blocks associated with the peer in purgePeer.
Closes#5513, #5517
* mempool: length prefix txs when getting them from mempool (#5483)
* correctly calculate evidence data size (#5482)
* block: use commit sig size instead of vote size (#5490)
* tx: reduce function to one parameter (#5493)
## Description
Check block protocol version in header validate basic.
I tried searching for where we check the P2P protocol version but was unable to find it. When we check compatibility with a node we check we both have the same block protocol and are on the same network, but we do not check if we are on the same P2P protocol. It makes sense if there is a handshake change because we would not be able to establish a secure connection, but a p2p protocol version bump may be because of a p2p message change, which would go unnoticed until that message is sent over the wire. Is this purposeful?
Closes: #4790
## Description
Add test vectors for all reactors
- [x] state-sync
- [x] privval
- [x] mempool
- [x] p2p
- [x] evidence
- [ ] light?
this PR is primarily oriented at testvectors for things going over the wire. should we expand the testvectors into types as well?
Closes: #XXX
Fixes#5192.
@liamsi Can you verify that the test vectors match the Rust implementation? I updated `ProofsFromByteSlices()` as well, anything else that should be updated?
While working on tendermint my colleague @jinmannwong fixed a few of the unit tests that we found to be flaky in our CI. We thought that you might find this useful, see below for comments.
## Description
This PR wraps the stdlib sync.(RW)Mutex & godeadlock.(RW)Mutex. This enables using go-deadlock via a build flag instead of using sed to replace sync with godeadlock in all files
Closes: #3242
- drop Height & Base from StatusRequest
It does not make sense nor it's used anywhere currently. Also, there
seem to be no trace of these fields in the ADR-40 (blockchain reactor
v2).
- change PacketMsg#EOF type from int32 to bool
check bcR.fastSync flag when "OnStop"
fix "service/service.go:161 Not stopping BlockPool -- have not been started yet {"impl": "BlockPool"}" error when kill process
## Description
this PR adds test vectors for proto encoding. the main difference from amino was the removal of four bytes due to interface encoding.
should i add more cases?
Closes: #XXX
## Description
partially cleanup in preparation for errcheck
i ignored a bunch of defer errors in tests but with the update to go 1.14 we can use `t.Cleanup(func() { if err := <>; err != nil {..}}` to cover those errors, I will do this in pr number two of enabling errcheck.
ref #5059
Closes#4603
Commands used (VIM):
```
:args `rg -l errors.Wrap`
:argdo normal @q | update
```
where q is a macros rewriting the `errors.Wrap` to `fmt.Errorf`.
Integrates the blockchain v2 reactor with state sync, fixes#4765. This mostly involves deferring fast syncing until after state sync completes. I tried a few different approaches, this was the least effort:
* `Reactor.events` is `nil` if no fast sync is in progress, in which case events are not dispatched - most importantly `AddPeer`.
* Accept status messages from unknown peers in the scheduler and register them as ready. On fast sync startup, broadcast status requests to all existing peers.
* When switching from state sync, first send a `bcResetState` message to the processor and scheduler to update their states - most importantly the initial block height.
* When fast sync completes, shut down event loop, scheduler and processor, and set `events` channel to `nil`.
Predominantly following the discussions regarding the conventions of using mocks, I have decided to revert back to the previous state where mocks were specialized and stored in the separate packages that used them rather then have a generalized mock in the evidence package.
This also was a problem as the state package were running tests too slow and occasionally timing out unnecessarily.
For the replay file I renamed mockEvidencePool to emptyEvidencePool to illustrate that it was intentionally like this and not give the impression that testing software was being used in production
Closes: #4786
The event loop uses a `select` on multiple channels. However, reading from a closed channel in Go always yields the channel's zero value. The processor and scheduler close their channels when done, and since these channels are always ready to receive, the event loop keeps spinning on them.
This changes `routine.terminate()` to not close the channel, and also removes `stopDemux` and instead uses `events` channel closure to signal event loop termination.
Fixes#4687.
Fixes#828. Adds state sync, as outlined in [ADR-053](https://github.com/tendermint/tendermint/blob/master/docs/architecture/adr-053-state-sync-prototype.md). See related PRs in Cosmos SDK (https://github.com/cosmos/cosmos-sdk/pull/5803) and Gaia (https://github.com/cosmos/gaia/pull/327).
This is split out of the previous PR #4645, and branched off of the ABCI interface in #4704.
* Adds a new P2P reactor which exchanges snapshots with peers, and bootstraps an empty local node from remote snapshots when requested.
* Adds a new configuration section `[statesync]` that enables state sync and configures the light client. Also enables `statesync:info` logging by default.
* Integrates state sync into node startup. Does not support the v2 blockchain reactor, since it needs some reorganization to defer startup.
to prevent malicious nodes from sending us large messages (~21MB, which
is the default `RecvMessageCapacity`)
This allows us to remove unnecessary `maxMsgSize` check in `decodeMsg`. Since each channel has a msg capacity set to `maxMsgSize`, there's no need to check it again in `decodeMsg`.
Closes#1503
## Description
Fixes a bug where the reactor would broadcast a base with height=0.
______
For contributor use:
- [ ] Wrote tests
- [ ] Updated CHANGELOG_PENDING.md
- [ ] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [ ] Updated relevant documentation (`docs/`) and code comments
- [x] Re-reviewed `Files changed` in the Github PR explorer
<!-- < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < < ☺
v ✰ Thanks for creating a PR! ✰
v Before smashing the submit button please review the checkboxes.
v If a checkbox is n/a - please still include it but + a little note why
☺ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -->
Fixes an issue reported in https://github.com/tendermint/tendermint/issues/4595#issuecomment-612667441.
Not sure if this is sufficient to fully remove the reactor, but it fixes the immediate problem.
______
For contributor use:
- [x] Wrote tests
- [x] ~Updated CHANGELOG_PENDING.md~
- [x] Linked to Github issue with discussion and accepted design OR link to spec that describes this work.
- [x] ~Updated relevant documentation (`docs/`) and code comments~
- [x] Re-reviewed `Files changed` in the Github PR explorer
* Added BlockStore.DeleteBlock()
* Added initial block pruner prototype
* wip
* Added BlockStore.PruneBlocks()
* Added consensus setting for block pruning
* Added BlockStore base
* Error on replay if base does not have blocks
* Handle missing blocks when sending VoteSetMaj23Message
* Error message tweak
* Properly update blockstore state
* Error message fix again
* blockchain: ignore peer missing blocks
* Added FIXME
* Added test for block replay with truncated history
* Handle peer base in blockchain reactor
* Improved replay error handling
* Added tests for Store.PruneBlocks()
* Fix non-RPC handling of truncated block history
* Panic on missing block meta in needProofBlock()
* Updated changelog
* Handle truncated block history in RPC layer
* Added info about earliest block in /status RPC
* Reorder height and base in blockchain reactor messages
* Updated changelog
* Fix tests
* Appease linter
* Minor review fixes
* Non-empty BlockStores should always have base > 0
* Update code to assume base > 0 invariant
* Added blockstore tests for pruning to 0
* Make sure we don't prune below the current base
* Added BlockStore.Size()
* config: added retain_blocks recommendations
* Update v1 blockchain reactor to handle blockstore base
* Added state database pruning
* Propagate errors on missing validator sets
* Comment tweaks
* Improved error message
Co-Authored-By: Anton Kaliaev <anton.kalyaev@gmail.com>
* use ABCI field ResponseCommit.retain_height instead of retain-blocks config option
* remove State.RetainHeight, return value instead
* fix minor issues
* rename pruneHeights() to pruneBlocks()
* noop to fix GitHub borkage
Co-authored-by: Anton Kaliaev <anton.kalyaev@gmail.com>
* format: add format cmd & goimport repo
- replaced format command
- added goimports to format command
- ran goimports
Signed-off-by: Marko Baricevic <marbar3778@yahoo.com>
* fix outliers & undo proto file changes
* test functions take time.Now and other minor changes
* updated remaining test files
* Update validation_test.go
* fix typo
* go fmt
* import time
Co-authored-by: Marko <marbar3778@yahoo.com>
Tess Rinearson
Anton Kaliaev
Marko
Callum Waters
Erik Grinaker
n-hutton
Lei Wang
Shivani Joshi