// Pinout configuration
const int grinderPin = 9, pumpPin = 8, boilerPin = 6, powderPin = 7, wheelPin = 10, invertWheelPin = 11, powderSensorPin = 2, vaporSensorPin = 5, tempSensorPin = 7, wheelStartSensorPin = 4, wheelEndSensorPin = 3, redLED = 13, greenLED = 12;

// Milliseconds to delay between each cycle
# define milliseconds 10;
int timeratio = 1;

void setup() {
  // put your setup code here, to run once:
  // first we set pins as I/O and initialize outputs LOW
  pinMode ((grinderPin, pumpPin, boilerPin, powderPin, wheelPin, invertWheelPin, redLED, greenLED), OUTPUT);
  pinMode ((powderSensorPin, vaporSensorPin, tempSensorPin, wheelStartSensorPin, wheelEndSensorPin), INPUT);
  digitalWrite((grinderPin, pumpPin, boilerPin, powderPin, wheelPin, invertWheelPin, redLED, greenLED), LOW);
  // timeratio easily allows to determine how many cycles are required to make 1s pass (ms * ratio = 1s)
  timeratio = 1000/milliseconds;
  // initialize serial:
  Serial.begin(9600);
}

void loop() {
  // put your main code here, to run repeatedly:

}