fixed press timing and boiler temperature

PyCoffeeNano/PyCoffeeNano.ino

@@ -1,5 +1,3 @@
-// LAST UPDATE: NOVEMBER 2024
-
 // Pinout configuration
 const int grinderPin = 9, pumpPin = 8, boilerPin = 6, powderPin = 7, wheelPin = 10, invertWheelPin = 11, powderSensorPin = 2, vaporSensorPin = 5, tempSensorPin = A7, wheelStartSensorPin = 4, wheelEndSensorPin = 3, redLED = 13, greenLED = 12;
 
@@ -204,7 +202,7 @@ void loop() {
 
   // making steam:
   while (digitalRead(vaporSensorPin) == HIGH) {
-    desiredTemp = 100;
+    desiredTemp = 110;
     Serial.write("Vapor heating\n");
     delay(500);
     Heat(); // Heat the boiler to vapor temperature
@@ -404,7 +402,7 @@ void Press() {
   while (true) {
     delay(milliseconds);
     if (digitalRead(wheelEndSensorPin) == HIGH) {
-      delay(90); // extra delay added to compensate for slightly incorrect endstop placement after repair
+      delay(1200); // extra delay added to compensate for slightly incorrect endstop placement after repair
       digitalWrite(wheelPin, LOW);
       delay(100);
       Serial.write("Pressed\n");
@@ -486,7 +484,7 @@ void makeCoffee() {
   // care must be taken to place these functions earlier in the code, or the compiler will rightfully freak out
   while (true) {
   
-  desiredTemp = 80;
+  desiredTemp = 90;
   Heat(); // First we pre-heat the boiler
   if (unrecoverableErr == 1) {
     break;
@@ -557,7 +555,7 @@ void makeCoffee() {
   if (dry == 0) {
     //digitalWrite(boilerPin, HIGH);
     delay(100);
-    desiredTemp = 95; // temperature to try and maintain while making coffee
+    desiredTemp = 100; // temperature to try and maintain while making coffee
     Pump(); // Pump ratio (in seconds) will be read from serial input in final release
     digitalWrite(boilerPin, LOW);
   }